广东省住房和城乡建设厅关于发布广东省标准《装配式混凝土结构检测技术标准》的公告

前　　言

引　　言

1　总　则

2　术　语

3　基本规定

4　材料检测

• 4.1　一般规定

• 4.2　混凝土

• 4.3　钢筋及钢材

• 4.4　连接材料

• 4.5　其它材料

5　预制构件进场检测

• 5.1　一般规定

• 5.2　混凝土强度

• 5.3　构件缺陷

• 5.4　尺寸偏差

• 5.5　钢筋配置

• 5.6　预制构件性能

6　安装与连接质量检测

• 6.1　一般规定

• 6.2　安装尺寸偏差

• 6.3　钢筋连接质量

• 6.4　预制竖向承重构件底部接缝灌浆质量

• 6.5　现浇混凝土连接质量

7　结构整体性检验

附录A　混凝土缺陷阵列超声成像法

附录B　预制构件粗糙面凹凸深度检测方法

附录C　用于量测灌浆套筒及连接钢筋中心线位置偏差的坐标定位法

附录D　灌浆套筒连接平行试件法

附录E　用于检测套筒灌浆饱满性的预埋传感器法

附录F　隔墙冲击试验

附录G　淋水试验

本标准用词说明

引用标准名录

1　General Provisions

2　Terms

3　Basic Requirements

4　Material Inspection

• 4.1　General Requirements

• 4.2　Concrete

• 4.3　Reinforcement and Steel

• 4.4　Interconnect Materials

• 4.5　Other Materials

5　Approach Check of Precast Concrete Component

• 5.1　General Requirements

• 5.2　Concrete Strength

• 5.3　Component Defects

• 5.4　Size Deviation

• 5.5　Arrangement of Reinforcement

• 5.6　Inspection of Component Performance

6　Erection and Connnection Inspection

• 6.1　General Requirements

• 6.2　Tolerances of Erection

• 6.3　Quality for Reinforcement Connection

• 6.4　Grout Quality for Bottom Seam of Precast Vertical Load Bearing Component

• 6.5　Quality for Cast-in-Situ Concrete Connection

7　Integrity Inspection of Concrete Structure

Appendix A　Inspection of Concrete Defect by Phased Array Ultrasonic Imaging Method

Appendix B　Inspection method of Bump Depth for Rough Surface of Precast Component

Appendix C　Axis Position Bars by Coordinate of Grout Sleeves and Dowel Orientation Method for Measuring Center Line Location Tolerances

Appendix D　Parallel Member Method of Grout Sleeve Splicing

Appendix E　Preburied Sensor Method for Measuring the Full Degree of Sleeve Grouting

Appendix F　Impact Test of Partition Wall

Appendix G　Water Pouring Test

Explanation of Wording in This Standard

List of Quoted Standards