中华人民共和国住房和城乡建设部公告

前言

1　总则

2　术语

3　基本规定

• 3.1　一般规定

• 3.2　系统形式的选择和设计要求

• 3.3　报警区域和探测区域的划分

• 3.4　消防控制室

4　消防联动控制设计

• 4.1　一般规定

• 4.2　自动喷水灭火系统的联动控制设计

• 4.3　消火栓系统的联动控制设计

• 4.4　气体灭火系统、泡沫灭火系统的联动控制设计

• 4.5　防烟排烟系统的联动控制设计

• 4.6　防火门及防火卷帘系统的联动控制设计

• 4.7　电梯的联动控制设计

• 4.8　火灾警报和消防应急广播系统的联动控制设计

• 4.9　消防应急照明和疏散指示系统的联动控制设计

• 4.10　相关联动控制设计

5　火灾探测器的选择

• 5.1　一般规定

• 5.2　点型火灾探测器的选择

• 5.3　线型火灾探测器的选择

• 5.4　吸气式感烟火灾探测器的选择

6　系统设备的设置

• 6.1　火灾报警控制器和消防联动控制器的设置

• 6.2　火灾探测器的设置

• 6.3　手动火灾报警按钮的设置

• 6.4　区域显示器的设置

• 6.5　火灾警报器的设置

• 6.6　消防应急广播的设置

• 6.7　消防专用电话的设置

• 6.8　模块的设置

• 6.9　消防控制室图形显示装置的设置

• 6.10　火灾报警传输设备或用户信息传输装置的设置

• 6.11　防火门监控器的设置

7　住宅建筑火灾自动报警系统

• 7.1　一般规定

• 7.2　系统设计

• 7.3　火灾探测器的设置

• 7.4　家用火灾报警控制器的设置

• 7.5　火灾声警报器的设置

• 7.6　应急广播的设置

8　可燃气体探测报警系统

• 8.1　一般规定

• 8.2　可燃气体探测器的设置

• 8.3　可燃气体报警控制器的设置

9　电气火灾监控系统

• 9.1　一般规定

• 9.2　剩余电流式电气火灾监控探测器的设置

• 9.3　测温式电气火灾监控探测器的设置

• 9.4　独立式电气火灾监控探测器的设置

• 9.5　电气火灾监控器的设置

10　系统供电

• 10.1　一般规定

• 10.2　系统接地

11　布线

• 11.1　一般规定

• 11.2　室内布线

12　典型场所的火灾自动报警系统

• 12.1　道路隧道

• 12.2　油罐区

• 12.3　电缆隧道

• 12.4　高度大于12m的空间场所

附录A　火灾报警、建筑消防设施运行状态信息表

附录B　消防安全管理信息表

附录C　点型感温火灾探测器分类

附录D　火灾探测器的具体设置部位

附录E　探测器安装间距的极限曲线

附录F　不同高度的房间梁对探测器设置的影响

附录G　按梁间区域面积确定一只探测器保护的梁间区域的个数

本规范用词说明

引用标准名录

1 General provisons

2 Terms

3 Basic requirement

• 3.1 General requirement

• 3.2 Choice and design of the system

• 3.3 Divide of the alarm zone and detection zone

• 3.4 Fire control center

4 Automatic control design

• 4.1 General requirement

• 4.2 Automatic control design of the automatic sprinkler system

• 4.3 Automatic control design of the fire hydrant system

• 4.4 Automatic control design of the gases（bubble）fireextinguishing system

• 4.5 Automatic control design of the smoke exhaust system

• 4.6 Automatic control design of the fire doors and fire roller shutter system

• 4.7 Automatic control design of the elevator

• 4.8 Automatic control design of the fire alarm and signalling device

• 4.9 Automatic control design of the fire emergency lighting system

• 4.10 Automatic control design of the related equipments

5 Fire detector choice

• 5.1 General requirement

• 5.2 Choice of the point type fire detector

• 5.3 Choice of the line type fire detector

• 5.4 Choice of the aspirating smoke detector

6 Setting of the equipment

• 6.1 Setting of the fire alarm control unit and automatic control equipment

• 6.2 Setting of the fire detector

• 6.3 Setting of the manual call point

• 6.4 Setting of the fire display panel

• 6.5 Setting of the fire alarm signalling device

• 6.6 Setting of the sounder equipment for fire emergency purposes

• 6.7 Setting of the fire telephone

• 6.8 Setting of the module

• 6.9 Setting of the graph indicator in fire control center

• 6.10 Setting of the routing equipment

• 6.11 Setting of the indicator and control unit for fire doors

7 Fire alarm and safety system installed in dwelling building

• 7.1 General requirement

• 7.2 System design

• 7.3 Setting of the fire detector

• 7.4 Setting of the fire alarm control unit for household

• 7.5 Setting of the fire alarm signalling device

• 7.6 Setting of the emergency broadcast device

8 Combustible gas detection and alarm system

• 8.1 General requirement

• 8.2 Setting of the combustible gas detector

• 8.3 Setting of the combustible gas control unit

9 Alarm and monitering system for electric fire protection

• 9.1 General requirement

• 9.2 Setting of the leakage current detector for electric fire prevention

• 9.3 Setting of the heat detector for electric fire prevention

• 9.4 Setting of the indepenedent detector for electric fire prevention

• 9.5 Setting of the alarm and control unit for electric fire protection

10 Power supply

• 10.1 General requirement

• 10.2 Ground connection

11 Wiring

• 11.1 General requirement

• 11.2 Interior wiring

12 Automatic fire alarm system for typical place

• 12.1 The trafic tunnel

• 12.2 The oiltank area

• 12.3 The cable tunnel

• 12.4 The large space places where higher than 12m

Appendix A Operating status information table for fire alarm&the fire equipment in the building

Appendix B Fire safety management information table

Appendix C Classification for the point type heat detectors

Appendix D Specific setting of the detectors

Appendix E Limit curve for Install space of the detectors

Appendix F Setting of detectors influened by roof beam

Appendix G Number of the roof beams protected by one detector based on the roof beams area

Explanation of wording in this code

List of quoted standards