首页 >标准规范

架空输电线路杆塔结构设计技术规定

Technical code for the design of tower and pole structures of overhead transmission line

会员免费阅读,去 购买

  • 标准信息
  • 中文目录
  • 英文目录
  • 公告
收起

标准信息

  • 【主编部门】
    电力规划设计总院
  • 【批准部门】

    国家能源局

  • 【发布单位】

    国家能源局

  • 【主编单位】

    中国电力工程顾问集团西南电力设计院;中国电力工程顾问集团公司

  • 【参编单位】

    中国电力工程顾问集团华东电力设计院;中国电力工程顾问集团西北电力设计院;中国电力工程顾问集团中南电力设计院;中国电力科学研究院

  • 【主要起草人】

    肖洪伟;郭跃明;梁政平;李喜来;段松涛;刘 勇;廖宗高;董建尧;王虎长;包永忠;李 正;翁炳华;邓安全;肖 兵;黄 璜

收起

中文目录

  • 国家能源局公告

  • 前 言

  • 1 总 则

  • 2 术语和符号

    • 2.1 术 语

    • 2.2 符 号

  • 3 荷 载

    • 3.1 一般规定

    • 3.2 正常运行情况

    • 3.3 断线情况

    • 3.4 不均匀覆冰情况

    • 3.5 安装情况

    • 3.6 验算情况

    • 3.7 导线及地线线条风荷载的标准值

    • 3.8 杆塔风荷载的标准值

    • 3.9 绝缘子串风荷载的标准值

  • 4 材 料

  • 5 设计基本规定

    • 5.1 计算的基本规定

    • 5.2 杆塔结构基本规定

  • 6 构件计算及断面选择

    • 6.1 铁塔构件计算及断面选择

    • 6.2 环形截面钢筋混凝土电杆的计算

    • 6.3 环形截面预应力混凝土电杆的计算

  • 7 连接计算

    • 7.1 螺栓连接

    • 7.2 焊缝连接

    • 7.3 节点板连接

    • 7.4 插入角钢连接

    • 7.5 塔脚板

    • 7.6 受拉构件的块剪

    • 7.7 组合角钢填板计算

  • 8 构造要求

    • 8.1 一般要求

    • 8.2 连接构造

    • 8.3 环形截面钢筋混凝土电杆

  • 9 附属设施

  • 10 环境保护

  • 附录A 塔身斜材的埃菲尔效应和最小承载力要求

  • 附录B 桁架内力分析简化表

  • 附录C 杆塔轴心受压构件稳定系数φ

  • 附录D 环形截面混凝土电杆斜截面承载力计算

  • 本标准用词说明

  • 引用标准名录

收起

英文目录

  • 1 General provisions

  • 2 Terms and symbols

    • 2.1 Terms

    • 2.2 Symbols

  • 3 Load

    • 3.1 General requirement

    • 3.2 Normal operation

    • 3.3 Wire breakage

    • 3.4 Non-uniform ice

    • 3.5 Installation

    • 3.6 Checking

    • 3.7 Characteristic value of wind load for conductor and ground wire

    • 3.8 Characteristic value of wind load for tower and pole structures

    • 3.9 Characteristic value of wind load of insulator string

  • 4 Material

  • 5 General provisions of design

    • 5.1 General provisions of calculation

    • 5.2 General provisions for tower and pole structures

  • 6 Calculation of member and selection of cross-section

    • 6.1 Calculation of tower members and selection of cross-section

    • 6.2 Calculation of circular sectional reinforced concrete pole

    • 6.3 Calculation of circular sectional pre-stressed concrete pole

  • 7 Calculation of connection

    • 7.1 Bolt connection

    • 7.2 Weld connection

    • 7.3 Node board connection

    • 7.4 Stub angle connection

    • 7.5 Tower footiing plate

    • 7.6 Block shear of tensile component

    • 7.7 Battern

  • 8 Structure requirements

    • 8.1 General requirement

    • 8.2 Connection requirements

    • 8.3 Circular sectional reinforced concrete pole

  • 9 Accessories

  • 10 Environmental protection

  • Appendix A The eiffel effect and minimum capacity of cross bearings

  • Appendix B Simplified analysis of truss

  • Appendix C Stability cofficient(φ)of axial compression member of tower

  • Appendix D Bearing capacity calculation of inclined sectional of circular sectional reinforced concrete pole

  • Explanation of wording in this code

  • List of quoted standards

收起

公告

国家能源局公告

3-30-01
2012年 第9号
按照《能源领域行业标准化管理办法(试行)》(国能局科技〔2009〕52号)的规定,经审查,国家能源局批准《压力容器法兰分类与技术条件》等63项行业标准(见附件),其中能源标准(NB)17项、电力标准(DL)9项、石油天然气标准(SY)37项,现予以发布。
附件:行业标准目录
国家能源局
2012年11月9日
附件:
行业标准目录
收起

本书术语

术语 英文名称 术语 英文名称
架空输电线路 overhead transmission line 轻、中、重冰区 light/medium/heavy icing area
基本风速 reference wind speed 稀有风速,稀有覆冰 rare wind speed,rare ice thicknees
杆塔长短腿 unequal leg extension 插入构件 stub
结构工作温度 structure work temperature

确定